Bypassing the BMW E36 passenger seat occupancy sensor

By · July 22, 2015 · 0 comments

The airbag warning lights on both of my BMW 318is's have been on for some time now and, because I now have my 4-door 1997 model up for sale, I thought it was time I did something about it.

I had previously read the fault codes for both cars and the problem was the same for each: passenger seat occupancy sensor fault.

The correct fix for this problem is to replace the seat sensor mat inside the passenger seat, but that didn't sound too easy to me.

However, there is plenty of information available online for various BMW models on how to bypass the sensor.

There seems to be quite a few ways of doing this, using combinations of various resistors, diodes and capacitors, some in series, some in parallel. I settled on one that seemed to be the most popular and got a few Dollars worth of parts from the local electronics store.

For each car I purchased two 100 ohm 0.25 watt resistors and one 1N4007 diode.

I removed the little electronic box that is clipped into and located underneath the passenger seat (turn it until it comes out) and unplugged the two connectors.

I pried open the box and used a soldering iron to remove the plug with the blue and white wire, noting which way the wires were located.

I soldered a resistor to each end of the diode (doesn't matter which way around resistors go).

bmw-e36-passenger-seat-occupancy-sensor-bypass.jpg

I then soldered the resistor connected to the end of the diode with the stripe to where the blue wire was connected, and the other end to where the white wire was connected.

I used some heatshrink tubing (electrical tape would do) to prevent any exposed electrical parts (such as the resistor and diode leads and the plug I removed) from touching anything else and put it back together.

Unfortunately the airbag light won't go off until it has been reset. Fortunately I have the BMW software and a cable purchased off eBay that enabled me to do this. Now my airbag light is off finally!

What does bypassing the sensor in this way actually do? It basically fools the system into believing a passenger is in the seat. This means that even if there is no passenger the passenger airbag will still go off. This might seem a bit of a waste of an airbag but if I have an accident that involves the airbags being deployed I'm sure it will be the least of my worries.

BMW E36 seat occupancy sensor bypass

BMW E36 seat occupancy sensor bypass

BMW E36 seat occupancy sensor bypass
Read more...
Technical Tips

Get the latest posts delivered to your inbox.

Comments

There are no comments yet. Be the first to leave a comment!

Leave a Comment

All comments are moderated and rel="nofollow" is in use. Avatars are sourced from gravatar.com – a globally recognised avatar.

Type the numbers from the picture above

About me
John Avis I am a bit of a 3 series fanatic, having owned a couple of E30s and a few E36s, plus a few parts cars. I like the combination of the compact size, good performance and handling, and that they are more sports sedan than an impractical and extrovert sports car. This blog is a place to share my experience and knowledge.
Subscribe

Get the latest posts delivered to your inbox. *